Troubleshooting
      Back to home
      1. Knowledge base - BCN3D
      2. Sigma Series
      3. Troubleshooting

      How to change the Y endstop (Sigma Series)

       

      EN

      ES

       

      Tools  
      allen-icon
      Allen key 2mm
      socket-driver-icon
      Socket wrench 5mm

      1. Go to Utilities/Maintenance/Move printing surface and lower the printing platform completely.

      Move printing platform

      2. Turn off and disconnect the printer.

      turn-off-d25 unplug-turn-off-d25

      3. Remove the top Z cable cover, follow this guide to do this: How to remove the Z cable cover (Sigma Series)

      sigma-d25-z-cover

      4. Unscrew and remove the right inner trim. screw-iconx4 M3 mm

       

      5. Unscrew the nuts that hold the Y endstop.

      		 nut-iconx2 M3

      remove-y-endstop-d25

      6. Detach the Y endstop and install the new one.

      y-endstop-d25

      Conclusions

      To reassemble the endstop follow the previous steps in the reverse order.

      Forum community 

      Repair didn’t go as planned? Check out our forum community for troubleshooting help.

       

      It's important to keep your printer in good shape to make the most out of it. In this chart, you can find a list of the extruder maintenance procedures and how frequently these should be done. Maintenance Plan

       

      bcn3d-recycle  Take your e-waste to a certified recycler. Check how we do it in BCN3D.

      Parts   Buy these parts
      x-endstop-component Y endstop SKU 10941

      RELATED ARTICLES
      check flat cable eng check mainboard fuse eng

       

      You can help improve the BCN3D Knowledge Base. 

      If you feel there are guides that we are missing or you found any error, please use this form to report it. Report form :)