How to remove the Z cable cover (Epsilon Series)

In this article you will learn how to remove the Z cable cover

 

Tools  
allen-icon
Allen key 2.5mm

To remove the inner cover, you'll have to disassemble the Z cable covers first. This article will show you how to proceed:

 

1. Raise up the printing surface: Utilities/Maintenace/Move printing surface.

epsilon-raise-platform

Note: If you can't move the printing surface from the touchscreen, spin the Z axis lead screw clockwise in order to move the surface up. Grab a piece of paper to have a better grip.

 

2. Turn off and disconnect the BCN3D Epsilon.

bcn3d-epsilon-turn-off-1

bcn3d-epsilon-turn-off-2

 

3. Remove the screws from the upper cover. screw-iconx4 M3 10mm

 

z-cable-cover-top

 

4. Remove the screws from the left and right side covers. screw-iconx6 M3 10mm

 

z-cable-cover-bottom

 

Conclusions

To reassemble, first screw the lateral covers and then the top cover. Be careful when you are reassembling the covers, an excess of pressure or a bad positioning can break them.

Forum community 

This article doesn't fix your issue? Check out our forum community for more info about this

 

It's important to keep your printer in good shape to make the most out of it. In this chart you can find a list of the extruder maintenance procedures and how frequently these should be done. Maintenance Plan

 

bcn3d-recycle  Take your e-waste to a certified recycler. Check how we do it in BCN3D.

 


RELATED ARTICLES

calibrate printing surface eng calibrate hotend eng

 

You can help improve the BCN3D Knowledge Base.

If you feel there are guides that we are missing or you found any error, please use this form to report it. Report form :)