How to install the shims (Epsilon series)

Install the shims to correct the Z offset between both nozzle tips







Shims are elements that mechanically correct the Z offset when printing in Mirror or Duplication mode. 


In these modes both toolheads work simultaneously, so it is key to make sure both nozzle tips are exactly at the same height. Due to manufacturing and assembly tolerances, the Z offset between tips can be up to 0.5mm. BCN3D printers automatically correct the offsets when printing in Mirror/Duplication Modes. Shims


However, this correction distorts the first layer of the model by repeating it as many time as needed. To avoid such distortion there are different options:

  1. Enable raft in BCN3D Cura: The offset will be corrected in the first layers of the raft, so the model won’t be affected by any Z offset.
  2. Install shims to mechanically correct the Z offset: Printing a raft takes time and spends material. For those users planning to use  Mirror or Duplication modes frequently, it is highly recommended to install the shims when it is suggested during the Printer Calibration process.

In this video you find the steps to be taken to install the shims.


Forum community 

Need more tips? Check out our forum community for more info.


It's important to keep your printer in good shape to make the most out of it. In this chart you can find a list of the extruder maintenance procedures and how frequently these should be done. Maintenance Plan.


bcn3d-recycle  Take your e-waste to a certified recycler. Check how we do it in BCN3D.



calibrate hotend eng


replace hotend eng


You can help improve the BCN3D Knowledge Base.

If you feel there are guides that we are missing or you found any error, please use this form to report it. Report form :)